PDA

View Full Version : Serrver radar messages



335th_GRAthos
Dec-28-2011, 05:52
I am getting puzzled by one thing gentlemen:

If I fly red, the ground operator gives me information about enemy planes in voice + text. The text reads something like
'enemy group, approximately 5 aircraft, sector L12, heading 240, altitude angels two, probably stukas'
very nice.

However, if I fly blue, the German operator gives a text message like below:
'enemy group,
heading 240, altitude 3500, Huricanes'
Notice that there is no indication in the text about the sector
The voice will mention the sector name in German (Konrad = K, Julius = J etc) but it will not appear in the text.

Is it only me that has this problem??????
It is very annoying because I have the sounds very low and normaly listen to music so most times I will miss the sector information.

~S~

ATAG_Bliss
Dec-28-2011, 05:58
I have my messages setup like this: http://theairtacticalassaultgroup.com/forum/showthread.php?694-InGame-Message-Windows-Setups

And I get the call-outs for all the information for both sides in text. I can not stand the AI voices and have had those disabled for quite a while.

Make a copy of your .ini and try the settings in the link and report back.. Sounds like it's something on your end.

335th_GRAthos
Dec-28-2011, 14:43
Thanks Bliss,

I will experiment a bit with the windows settings of the link you posted.

But it may not be an InfoWindows problem, you see, I get the text.
but when I fly red I see the map quadrant type on the InfoWindow whereas when I fly blue, I do not see the map quadrant information on the InfoWindow.
Which does not make logical sense...

Since you fly blue, do you read the map quadrant info when the operator speaks in your chat window?
Or do you see only 'enemy group, heading 240, altitude 3500, Huricanes'

~S~

ATAG_EvangelusE
Dec-28-2011, 19:19
Confiirm, I see the map grid references on Blue side exactly as for Red.

335th_GRAthos
Jan-01-2012, 19:26
I am getting crazy...

This is what I see when I fly red
http://grathos.de/temp/CoD/RedChat1.jpg
(The Red side has a lot of different types of messages but always the map coordinates are mentioned)

This is what I see when I fly blue
http://grathos.de/temp/CoD/BlueChat1.jpg
No map square mentioned (although the German voice mentions it)


And these are my settings for this window
http://grathos.de/temp/CoD/WindowSetup.jpg

Any idea what I may be doing wrong and the Blue map coordinates are not mentioned?

~S~

ATAG_Bliss
Jan-01-2012, 21:52
That's strange Grathos :inq:

Have you tried just removing the .ini and letting the game create a new one? That way you'd at least see if your setup was causing it. I use the sticky thread for info windows for my setup. Perhaps try copying that code in and re-test as well?

335th_GRAthos
Jan-02-2012, 03:14
Have you tried just removing the .ini and letting the game create a new one?

I knew this will come to haunt me one day...:happy
No, original conf.ini since April 2011 :Grin:

Yeah, I will give it a try rebuilding my conf.ini :sad!:

~S~

ATAG_Bliss
Jan-02-2012, 03:25
I knew this will come to haunt me one day...:happy
No, original conf.ini since April 2011 :Grin:

Yeah, I will give it a try rebuilding my conf.ini :sad!:

~S~

:laugh::laugh:

But seriously, don't rebuild it. The only thing you have to do is open it up and copy/paste under the chat window section. I would use what's in that sticky thread as a base to start with just to see if that fixes your problem. Then you can go hog wild and screw it up from there :Grin:

335th_GRAthos
Jan-02-2012, 17:42
:TYTY!:

T H A N K S !!!!

http://grathos.de/temp/CoD/BlueChatGood.jpg

It was that I had two lines only for the Info windows and the Blue radar info was four lines long! :bricks:

~S~

Ajay
Jan-15-2012, 22:49
I have not got my server messages set up correctly yet but will by tonight :)

Those co-ord's that get called out , are they for all planes or AI only ?

335th_GRAthos
Jan-16-2012, 02:23
all planes

~S~