DEVICELINK - error/omission

[1lokos]

Dont know if this is fixable, just in case:

Blenheim

Instead read the parameters for:

C_WaterRadiator.1 = in Blenheim cowl flaps for left engine (1)
C_WaterRadiator.2 = in Blenheim cowl flaps for right engine (2)

The Device Link read only

C_WaterRadiator.0; (single engine plane)

The existent Virtual Cockpit for Blenheim use the parameter (C_WaterRadiator.0; ) for both engines, so one that select engines and look only at Virtual Cockpit can end with one engine overheat...

Spitfire

Devicelink don't read the parameter for:

C_RudderTrim (trim available in this plane)

[maxwitt]

Hey LOkos!

I think I understood your request and I gonna try to respond (my english is not good).

On the Blenheim, you have on your right just one steering wheel for both engines water radiator.
So I think it s historical if you can't take control separately.


I' m good?

[1lokos]

Hey LOkos!

I think I understood your request and I gonna try to respond (my english is not good).

On the Blenheim, you have on your right just one steering wheel for both engines water radiator.
So I think it s historical if you can't take control separately.


I' m good?

Understood, your historical approach is correct.

The thing is the game engine selection affect this command.

If I select engine 1 and move the (radiator) wheel, only engine 1 cowl flaps will open, but VC inform that both are open.

Well, in this case is better I remove sliders for radiator in VC and look at engines cowls, no more "accidents".

As curiosity, from Blenheim Pilote Notes:



For Mk.V is show two wheels for "cowling gill" - early models - but for Mk.IV looks only one (description page not found).