For this kind of bicycle brake adaptation, use Honeyweel SS495A1 or Allegro A1324EUAT, they are very sensitive - so don't require much turn of magnet, small, work in analog mode (+5V Gnd, Signal wires).
You will not achieve bigger resolution in this axis - due the limited lever movement the magnet will turn little, but sufficient for brake in any game.
When I install HALL sensor in CH pedals for a squad mate, face this problem of limited turn movement on magnet, but in the end achieve around 900 "points of resolution" in that axes - considering the 256 points of original CH controller, a good improvement.
In DCS forum Troll user make brake lever for Warthog using an load cell (like in ForceSense joysticks).
BTW - UO53 in Aviasim make this intriguing brake lever design - using GVL224 MagREZ sensor, but the above mentioned HALL sensor can be used in place.
http://avia-sim.ru/forum/viewtopic.p...=759&start=180
Bookmarks