Bf 109 and G50 rad settings

[ATAG_Endless]

Hey guys for a few weeks now I've been playing around with the radiators on the bf109 and the G50 and I think I've found a good set up for rad settings for certain scenarios although this works for me it might not be for everyone as it increases work load but also increases efficiency and survivability

Bf 109 rpm 2000-2400 never exceed the rpm's past 2400 as you will blow your motor

Bf 109

1 # level flight
oil rad 50-60%
Water rad 65 - 75%
Ata 1.2 or less

2 # shallow dive attack
Oil 55%
Water 65-75%
Ata full power

3# shallow climb
Oil 60 %
Water 75-100 % 75% if climbing at 350kph and 75-100% if climbing at 300kph
Ata 1.2

4 # steep climb
Oil 75%
Water 85-100%
Ata full at start of climb bring back to 1.2-0 at top of climb

5 # out run opponent WEP
Oil 40%
Water 50-100% start at 50% and as you gain seperation open rad to 75 -100%
Depending on engine temp as it will be on its limits
Ata wep ( war emergency power )
Shallow dive will reach 500 -520kph that is 310-323mph and will give you time to call for help as the spit will be struggling to pull you in

6# out run opponent no WEP
Oil 50%
Water 65-75% - open or close on your own judgement based on engine temps
Ata full 100% throttle will reach 490-500 kph on the deck .

G50
All purpose set and forget
Oil rad 65%
Air rad 65%
Boost cutout on
Prop pitch 3 clicks down ( 85% )
110% throttle
Will get up to 420-430 kph in level flight


ALL these setting have been tested under combat scenarios but you must be vigilant in watching and adjusting water temps to maintain a healthy engine